Hifonics GA-3000.1D Amplifier 3000 Watt Mono 1-Ohm Stable - 1-Channel
-
LOW NOISE PRE-AMPLIFIER CIRCUITRY
Maximum low voltage signal from the source unit comes into the amplifier circuit with minimal distortion -
RCA INPUTS
Nickel-plated RCA jacks create the most effiecient audio connection and resist corrosion -
OPERATION MODE
Mono only -
CROSSOVER TYPE
Internal crossovers networks allow for audiophile control of equalization circuits -
ELECTRONIC EQUALIZER
Control of amplifier output with on-board electronic crossover to tailor specific frequencies to speakers and subwoofers.
Check specifications for specific frequencies for this amplifier -
CLASS / TOPOLOGY
Super D-Class™ designs which employ high-speed microprocessors with proprietary D/A conversion algorithms to efficiently control the current consumption. At very high listening levels, Hifonics amplifiers with Super D-Class circuitry result in lower distortion, higher current efficiencies and less heat than conventional D-Class amplifier designs -
OUTPUT DEVICE TECHNOLOGY
The Ultra-Fi™ MOSFET is designed for music production vs just electronics output power. It produces very musical high power with high efficiency for cooling and minimal distortion -
HEAT SINK
Classic aluminum Hifonics design to minimize heat build up on the Ultra-Fi™ output devices -
POWER SUPPLY
Simpatico Coil Design
The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices -
OUTPUT CONNECTIONS
High temperature impact resistant nickel plated connectors with allen head set screws which allow for secure termination of wire and creates an erosion resistant seal -
CONNECTION TYPE
Molded and Angled
Secure connection for all Power, Ground and Speaker connections. Angled for ease of access while creating a clean wire mangement profile -
FULL-RANGE RCA OUTPUTS FOR SIGNAL PASS THROUGH
Preamp RCA outputs to daisy chain multiple amps eliminate additional signal cables from the source unit -
LED SYSTEM PROTECTION CIRCUITRY DIAGNOSTICS
Monitor overload and speaker short protection with illuminated indicators on the amplifier end panel -
BASS REMOTE INCLUDED
Wired Bass Remote allows adjustments to bass frequencies from the control which can be mounted anywhere in the vehicle. -
PHASE ADJUSTMENT
Phase 0-180°.
-
CLASS
Super D Class™ -
VARIABLE VOLTAGE
9V - 0.2V -
SIGNAL TO NOISE
>95dB -
FREQUENCY RESPONSE
10Hz-50KHz -
CROSSOVER
Variable
Electronic -
VARIABLE LOW PASS CROSSOVER 12DB PER OCTAVE
30Hz - 250Hz -
BASS BOOST
0 - 10dB -
SUBSONIC FILTER
15Hz - 35Hz -
PHASE SHIFT
0-180° -
POWER @ 1 OHM
1 x 3000 -
POWER @ 2 OHMS
1 x 1500 Watts -
POWER @ 4 OHMS
1 x 750 Watts -
MONO BRIDGED @ 4 OHMS
N/A -
TOTAL CHANNELS
Mono Only -
AUDIO INPUTS
RCA -
AUDIO OUTPUTS
1 Pair
Full Range
RCA -
POWER TERMINAL 12V/GND
0 AWG -
SPEAKER TERMINAL WIRE GAUGE
10 AWG -
FUSING
External 225A -
TOTAL HARMONIC DISTORTION (THD)
<0.10%
Detail information
You can use external link or upload a size guide image here.
Esta secção não inclui de momento qualquer conteúdo. Adicione conteúdo a esta secção através da barra lateral.